74
HUNTER-PRO 896 Installation Guide
6 R
EMOTE
C
ONTROL VIA
T
OUCH
-
TONE
T
ELEPHONE
HUNTER-PRO 896 can be remote-controlled via any touch-tone telephone, including
cellular. The system can be controlled in one of two options:
Mode A: Basic commands, including arming and disarming (the default mode).
Mode B: Full control, including all the outputs
Note
: The entire chapter applies both when you call the system and vice verse
6.1 Mode
A
1.
Dial the telephone number the system is connected to.
2.
Wait for confirmation tone (a long tone followed with two beeps)
3.
Enter Master Code
4.
Wait for status tone:
Continuous: The system is disarmed
Beeps: The system is armed
Note
: The system will not respond to commands while playing the confirmation tone.
It is important to wait until the confirmation tone is over before pushing any telephone
key.
5.
Push a key according to the next table. The system confirms the command
with two short beeps.
The following table includes system’s commands by telephone keys:
key Function
Stop external siren and dialer. The dialer will not dial to any more numbers
Arm the system
Disarm the system
Arm the system to “Home 1” mode
Switch the (PCB) relay ON
Switch the (PCB) relay OFF
Arm the system to “Home 2” mode
Listen in for one minute (only available with MIC-200). To extend listen in time (in
one minute), push again as needed.
While the system and the remote telephone are communicating with each other, the
following message will display on all connected keypads: “Other keypad in use”.
