HUNTER-PRO 896 Installation Guide
57
5.4.12 MS2
Options
3
ENTR
ENTR
NEXT
X11
Communication
ENTER/NEXT/END
MS2 Options
ENTER/NEXT/END
AA12PFDMOLTWIR
++++++++++++++.2
MS 2 Protocol
0
0
ENTR
Set Monitoring Station #2 options.
5.4.12.1 MS2
Protocol
Set MS2 PSTN protocol. Setting this protocol will indicate the system to report to 2
monitoring stations.
Note
: In order to report to two Monitoring Stations with two different account ID
numbers, in addition to setting the protocol, mark “+” under parameter “S” (Split
Subscriber) in “Communication Options” menu (section
5.4). In this case, Account 1
numbers will be sent to MS1 while Account 2 numbers to MS2.
To disable reporting to MS2, set its protocol to 0, 0.
5.4.12.2
MS2 Report Parameters
Set the parameters the system will report to Monitoring Station 2. All parameters are
similar to those of Monitoring Station 1 as described in section
5.4.1 but the radio
option: you cannot report to MS2 via radio.
5.4.13 Advanced
Programming
Note
: Advanced programming may require professional knowledge in communication
protocols. Beware not to change parameters unless you checked it with the cellular
provider first.
3
ENTR
ENTR
BACK
Communication
ENTER/NEXT/END
Advanced Prog.
ENTER/NEXT/END
Choose Provider
ENTER/NEXT/END
ENTR
Cell. Providers
GSM PROVIDER 1
5.4.13.1 Choose
Provider
Set the cellular provider for the GSM SMS service. The system is pre-programmed with
unique parameters to every provider and these should usually not be changed. Up to 5
providers can be programmed.
to save.
5.4.13.2
Cellular Provider’s Details
Choose Provider
ENTER/NEXT/END
NEXT
Cell. Providers
ENTER/NEXT/END
Cell. Providers1
ENTER/NEXT/END
ENTR
...
In the following screens the details needed for the system to contact the cellular
provider’s SMS center are entered. This information should be provided by the cellular
provider. The next screens are:
