HUNTER-PRO 896 Installation Guide
51
Par.
Description
Enabling this parameter means…
P
Connected T.Line
A telephone line is connected to the system
T
No Dia. tone chck
The system dials without checking for a dial tone (in
case the system connected via switch-board or the
line is not clear)
L
Line Test in ON
The system tests the phone line (once a minute) when
it is armed
L
Line Test in OFF
The system tests the phone line (once a minute) when
it is disarmed
T
Tone Dial
“+” For DTMF
“-“ For Pulse
A
Answer. Machine
If answering or fax machine are attached to the
phone line, the system snaps incoming call following a
sequence of two rings, hang-up, 10 seconds pause
and a ring.
Note
: Set the answering machine to pick calls after more than 2 rings.
V
Voice Unit
VU-20 voice unit is connected to the system.
D
Download Disable
Downloading parameters from COMAX via modem is
disabled. To temporarily allow it, enter Master code
and
X2 (only valid for two minutes.)
R
Rem. Disarm Disab
The option of remotely disarming the system by the
telephone is disabled.
P
Pre Alarm Report
The system sends a report when Entry Delay starts.
O
Tst Rprt in OFF
Test reports are sent when the system is disarmed.
S
Split Account No.
When reporting to 2 MSs (with different account
numbers), account #1 will be reported to MS1 and #2
to MS2. Assigning account number per partition is
disabled.
D
Disarm after Al.
The system will report an open event occurring
immediately after alarm, even when the open/close
parameter is disabled (in MS1 options menu).
5.4.4.1
Number of Rings
No. of Rings 10
Set the number of rings before the system picks up an incoming call. To manually
answer,
Master code
X2
