PIKA Mosport 1E-F, Руководство по установке оборудования, Страница: 22 / 64

Chapter 2 - Installation Location and Mounting Requirements
12 Mosport 1TE/2TE
The following guidelines are provided to ensure your safety:
• Mount the Mosport 1TE/2TE at the bottom of the rack if it is the only unit in the rack.
• When mounting the Mosport 1TE/2TE in a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the Mosport 1TE/2TE in the rack.
8. Proceed to “Hardware Installation” on page 14 .
Wall-Mounting
You can use the mounting brackets to wall-mount a single Mosport 1TE/2TE.

To wall-mount the Mosport 1TE/2TE:
1. Disconnect all of the cables from the Mosport 1TE/2TE before mounting, if applicable.
2. Ensure that the wall you are using is smooth, flat, dry and sturdy. Attach a piece of plywood,
approximately 305 mm x 510 mm x 12 mm (12 inches x 20 inches x 0.5 inches) securely to the wall,
if necessary.
3. Place the Mosport 1TE/2TE right side up on a hard flat surface, with the front facing toward you.
4. Place one bracket over the mounting holes on the left side of the Mosport 1TE/2TE and align the
bracket with the screw holes and tab hole as illustrated in
Figure 9 .
Figure 9: Wall-Mounting Installation
Table 8 describes the mounting pieces you need to wall-mount the Mosport 1TE/2TE.
5. Insert the two screws in the mounting bracket, and then tighten.
Caution:
You can wall-mount the Mosport 1TE/2TE with either the right or left side facing up; however, the
front and rear panels must be vertical.
Table 9: Wall-Mounting Pieces
Item Qty. Description
A 1 Mosport 1TE/2TE casing
B 2 Bracket
C 8 18-8 SS Flat Head Philips Machine Screw 8-32 Thread, 5/16" Length
A
C
B
Note:
Use the screws supplied with the mounting brackets. Damage caused to the unit by using incorrect
screws invalidates your warranty.