PIKA Mosport 1E-F, Руководство по установке оборудования

Страница: 29 / 64

RESET/DEFAULT Button Hardware Installation Guide
Mosport 1TE/2TE 19
RESET/DEFAULT Button
The RESET/DEFAULT button allows you to:

Cancel an action that was started.

Revert to known factory settings if the Mosport 1TE/2TE refuses to work properly for any
reason or the connection to the network is lost.

Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time – you can press the button while the Mosport 1TE/2TE
is running without powering the unit off. Table 12 describes the actions you can perform in this case.
Ethernet
No network traffic, 100 Mbits/s Steady green
No network traffic, 10 Mbits/s Steady orange
Network traffic, 100 Mbits/s Blinking green, variable rate
Network traffic, 10 Mbits/s Blinking orange, variable rate
In Use
Lines Idle and Unlocked Off
Lines InUse and Unlocked Steady green
Shutting Down Steady yellow
Locked Blinking yellow, 1 Hz, 50% duty
a. The ERROR/ALARM and ERROR/TROUBLE indicators do not currently have individual
behaviours like the other indicators.
Table 11: Default LED Behaviour (Continued)
LED Type
a
Condition Behaviour
Table 12: RESET/DEFAULT Button Interaction
RESET/
DEFAULT Button
Pressed for:
Action Comments LEDs Pattern
2 to 6 seconds Restarts the Mosport
1TE/2TE No changes are made to the
Mosport 1TE/2TE settings. Power LEDs:
• blinking green,
1Hz, 50% duty
All other LEDs:
• OFF
7 to 11 seconds Sets the Mosport
1TE/2TE in Partial
Reset Mode Sets some of the Mosport 1TE/
2TE configuration to pre-
determined values. All LEDs
• blinking, 1Hz,
50% duty
12 to 16 seconds Restarts the Mosport
1TE/2TE in Factory
Reset Deletes the persistent
configuration, creates a new
configuration file with the default
factory values, and then restarts
the unit. All LEDs
• steady ON
17 seconds and
more No action is taken The RESET/DEFAULT Button
Pressed event is ignored N/A