PIKA Mosport 1E-F, Руководство по установке оборудования, Страница: 21 / 64

Location and Mounting Requirements Hardware Installation Guide
Mosport 1TE/2TE 11
Rack-Mounting
The Mosport 1TE/2TE fits in most standard 48.26 cm (19 in.) racks. PIKA recommends to use a rack compliant
EIA-310-D.
All LEDs located on the front panel are also duplicated on the rear of the Mosport 1TE/2TE, which allows you
to rack-mount the unit with the front or the rear facing forwards.

To rack-mount the Mosport 1TE/2TE:
1. Disconnect all of the cables from the Mosport 1TE/2TE, if applicable.
2. Place the Mosport 1TE/2TE right side up on a hard flat surface, with the front or rear facing toward
you according to the way you want to insert it in the rack.
3. Place one bracket over the mounting holes on the left side of the Mosport 1TE/2TE.
• For a front facing installation, place the bracket at the front of the unit.
• For a rear facing installation, place the bracket at the rear of the unit, inverted.
4. Align the bracket with the screw holes and tab hole as illustrated in Figure 8 .
Figure 8: Rack-Mounting Installation
Table 8 describes the mounting pieces you need to rack-mount the Mosport 1TE/2TE.
5. Insert the two screws in the mounting bracket, and then tighten.
6. Repeat steps 3, 4 and 5 for the other side of the Mosport 1TE/2TE.
7. Insert the Mosport 1TE/2TE into the rack and secure with suitable screws (not provided). Be sure
that the fan is not obstructed.
To prevent bodily injury when mounting or servicing the Mosport 1TE/2TE in a rack, ensure that the
rack remains stable.
Standards Supported • EIA-310-D
• ETS 300 119
Table 8: Mounting Pieces
Item Qty. Description
A 1 Mosport 1TE/2TE casing
B 2 Bracket
C 4 18-8 SS Flat Head Philips Machine Screw 8-32 Thread, 5/16" Length
A
B
C
Front Facing Installation Rear Facing Installation
Note:
Use the screws supplied with the mounting brackets. Damage caused to the unit by using incorrect
screws invalidates your warranty.