OPERATING AND INSTALLATION INSTRUCTIONS LBE 250 / LBE 500
PAGE 15
9.2 AUTOMATIC ACTIVATION/DEACTIVATION (AUTO STANDBY)
• If the On/Off button is pressed, the following appears on
the display:
auto STANDBY.
• The air humidification unit is switched off and set to the
auto STANDBY mode.
• If the air humidity falls by 7 % under the set value for a
period of 24 hours, the air humidification unit switches
on again.
a
uto S
TANDBY
9.3 MANUAL ACTIVATION/DEACTIVATION (MANU STANDBY)
• If the
On/Off button
on the key pad is
pressed for longer
than 3 seconds
, the following appears on the display:
manu STANDBY
.
• In this operational status, the air humidification unit re-
mains switched off. The water is drained and the UVC
pipe and the rotor are switched off with a delay of 20 mi-
nutes.
• The air humidification unit must be switched on again by
hand. To do so,
press the On/Off button for 3 seconds.
manu STANDBY
9.4 AUTOMATIC ACTIVATION/DEACTIVATION DEPENDING ON AIR CURRENT („CONTROL OFF“)
• The humidification is controlled automatically by the
operation of the ventilation device. In the process, an
acoustic signal indicates whether the ventilation and air
conditioning system is running.
• Depending on this signal, the air humidification unit
switches
on and off automatically.
• If the ventilation and air conditioning system is shut
down for longer than 18 hours,
the air humidification
unit switches off automatically. Auto STANDBY.
• During the operation of the ventilation and air conditio-
ning system, it switches on automatically again.
/
CONTROLL ON
CONTROLL OFF
a
uto S
TANDBY
9.5 RINSING
• The water inlet pipe and the reverse osmosis membrane
are protected against germs by the rinsing program.
• The rinsing program is performed automatically once a
day while the air humidification unit is shut down. „RIN-
SING“ is shown in the display.
• The rinsing period amounts to 10 minutes and can be
cancelled by pressing the „Back“ button.
RINSING
• This parameter indicates that the humidity and air tem-
perature control are active.
9.6 CONTROL ON
CONTROL ON
• This parameter indicates that the tank is being filled
with water.
FILL
9.7 FILL
US
ER
G
ENER
A
L
S
PE
CI
A
LI
S
T PER
S
O
NNEL
