Phobos P430, Руководство пользователя

Страница: 55 / 81

or
# ifup plinkX (if you are using PhobosLink)
L O A D I N G
P
H O B O S
L
I N K
D
R I V E R
This section shows you how to install and configure PhobosLink, the
port aggregation software from Phobos. The P430 NIC is config-
urable into any combination of logical and physical interfaces using
the Phobos Installation software. For example, you can configure 3
logical interfaces using two of the P430 ports for one interface and have
the other two ports as regular 10/100Base-T connections, or you can
configure a single logical interface using all 4 of the P430 ports as
a single trunk, creating aggregate bandwidth of 400Mbps.
The installation is the same as for the P430 driver software. Refer to
the beginning of Chapter 6. Solaris must be up and running. Use the
installation disk (CDROM) that came with your P430. The NIC
should already be installed in your machine.
1. Install the P430 and PhobosLink drivers by following s t e p s
1-3 in the section “Load and Configuring the P430 Driver”,
previously described in this Chapter. Make sure the ‘all’ drivers
are installed in step 3.
C O N F I G U R I N G
P
H O B O S
L
I N K
1. Launch the PhobosLink application by typing:
# plink_config
Once the software is loaded, the screen shown in figure 7-1 will
appear: In this window, you create links by selecting interfaces from
the “Available Interfaces” window.
2. Click “Create Group.” A new group will appear in the window
representing your new trunk.
7-4