Pereko KSR Beta Pelet 16, Руководство по эксплуатации и обслуживанию

Страница: 129 / 184

37
materials used for floor or CH installation designer state differently.
Valve opening time
Set full valve opening time given at the plate of valve servomotor, i.e.
140s.
Pump off by thermostat
Setting the parameter on “ YES ” value causes closing of mixer
servomotor and deactivating mixer pump after disconnecting joints of
room thermostat. This is not recommended because the heated room
can be too cool.
Mixer input dead zone
Setting parameter determining value of temperature dead zone for
mixer controlling circuit. The controller regulates mixer in such a way
to keep the temperature of mixer cycle equal to preset value.
However, avoid too frequent movements of servomotor, which can
shorten its long-life usage. Regulation is undertaken only when
measured temperature of mixer cycle will be higher or lower than
preset value by the value bigger than
Mixer input dead zone .
14.6 OTHERS
Show advanced setup
Options available:
x
YES (displays hidden parameters which edition is not
recommended).
x
NO (hides hidden parameters).
Output H mod A
Output H mod B/C
Output H mod A:
x
Boiler reserve – output 39-40 controls the reserve boiler.
x
Alarms – the alarm output is activated 39-40. It allows to select
the alarm on which the output H mod A it react.
x
Circulation pump - output 39-40 controls the circulation pump.
x
Signaling of operation – output 39-40 voltage is applied
continuously in all operating modes of the controller. The voltage
is taken only when the controller is switched off.
Output configuration H (mod B / C) is only available when connecting
additional modules B and C.
Restore service settings Restoring service settings settings from main menu are restored.