Pereko KSR Beta Pelet 16, Руководство по эксплуатации и обслуживанию

Страница: 159 / 184

23
10. Technical data
Power 230V~; 50Hz;
Current consumed by controller 0,04 A 4
Maximum nominal current 6 (6) A
Controller’s level of protecti on IP20
Outer temperature 0...50 q C
Storage temperature 0...65 q C
Relative humidity
5 - 85% without
condensation of
water steam
Measuring scope of sensors’
temperature CT4
0...100 q C
Measuring scope of sensors’
temperature CT4-P
-35...40 q C
Accuracy of measuring
temperature with sensors CT4
and CT4-P
2 q C
Clamps
For network
and signal
Screw, cable section
to 2.5mm2,
tightening torque
0,4Nm, isolation
length 7mm
Protecting
Screw, cable section
to 2,5mm
2 ,
tightening torque
0,5Nm, isolation
length 6mm
Display
Colorful, graphic,
480x272 with touch
panel
Dimensions 224x200x80 mm
Weigth 1,4 kg
Norms
PN-EN 60730-2-9
PN-EN 60730-1
Software class A
Protection class
For installing to
devices class I
Level of contamination
2
wg PN-EN 60730-1
11. STORAGE AND TRANSPORT
CONDITIONS
The controller cannot be exposed to
immediate effects of atmospheric conditions
i.e. rain or sunrays. Temperature of storage
4 It is a current collected by the controller (when
connected 2 executive modules and a panel). Total
electricity consumption depends on devices which are
connected to the controller.
and transport should be within scope - 15…65
degrees C.
During transport the controller cannot be
exposed to vibrations bigger than typical for
transport of boilers.
12. CONTROLLER INSTALLATION
12.1 ENVIRONMENTAL CONDITIONS
Due to fire risk it is forbidden to use the
controller in proximity of explosive gases or
dust. Moreover the controller can not be
used in conditions of water steam
condensation or be exposed to effects of
water.
12.2 INSTALLATION REQUIREMENTS
The controller should be installed by a
qualified
and authorized installer, in
accordance with current norms and
regulations. The producer is not responsible
for damages caused by failing to observe
valid law and this user manual. The
controller is designed to be built-in. This
means that it is attached to flat and stable
part of a boiler or a wall. It cannot be used
as a separate device. Leave free space at
each partition of the controller (save for
assembly partition) at least 50mm. Leave
free space allowing for setting wires without
bending them, at least 100mm from back
partition of the controller. Outer temperature
and assembly surface should be within scope
of 0
– 50 degrees C.