Pereko KSR Beta Pelet 16, Руководство по эксплуатации и обслуживанию

Страница: 108 / 184

16
x Calibration
Fill the container to the level which
corresponds to full level of fuel, then set
value of parameter:
Boiler settings – Fuel level – Fuel level
calibration – Fuel level 100%
In main window the indicator will be set on
100%. The calibration process is marked
with a pulsating fuel level indicator. The
indicator will pulsate until programming point
referring to minimum fuel level. Decreasing
level of fuel in the container should be
monitored constantly. When fuel level
reaches expected minimum, parameter value
should be set this way:
Boiler settings
→
Fuel level
→
Fuel level
calibration
→
Fuel level 0%
8.22 Cooperation with additional
feeder
After connecting additional B module the
controller can cooperate with low fuel level
sensor in container. After activating sensor,
for
Additional feeder time controller will
connect auxiliary feeder to refill basic fuel
level. This parameter can be found in:
Service settings
→
Burner settings
→
Other
8.23 INFORMATION
Graphical layout of the system operation,
preview of parameters and operation modes,
mixer settings, WiFi/Ethernet web module
parameters, service counters and versions of
the controller programmes are visible in the
Information menu.
Pic. 12 System visualisation including current reading of
the operating parameters.
8.24 MANUAL CONTROL
In the controller it is possible to manually
activate devices like i.e. pumps, feeder
engine, or blower engine. It enables to check
if the device is operating correctly and if it is
connected properly.
Attention: Entering manual control
is possible only in STAND-BY mode,
when container is switched off
Pic. 13 Manual control window view, when OFF – means
that the device is off, ON – activated.
Attention: long lasting activating of
fan, feeder or other device may
cause danger.