Pereko KSR Beta Pelet 16, Руководство по эксплуатации и обслуживанию

Страница: 13 / 184

13
Page Operation and maintenance manual for the KSR Beta Pelet series boilers with feeders. The producer reserves the right to introduce technical modifications.
4. SERVICE MANUAL
4.1. Safe operating conditions
To maintain safe operating conditions for the boiler you should:
• Execute heating system correctly in compliance with the
requirements of the standards: PN 91/B-02413, applying to
the protection of open water heating installations, consider-
ing the Regulation of the Minister of Infrastructure, Journal of
Laws of 2009, no. 56, item 461.
• Fill the system with water correctly. Do not re fi ll the system
with cold water during operation of the hot boiler.
• It is forbidden to operate the boiler if the water level in the
system is below the level indicated in the central heating
system user manual.
• Never use fl ammable liquids, e.g. petrol, for fi ring up.
• Do not extinguish the fi re in the furnace by pouring it with
water.
• Use suitable equipment and protective clothing (gloves,
goggles, head protection, shoes) during work with the boiler
and take special care during servicing of non-insulated com-
ponents (e.g. doors), which may heat up to high tempera-
tures resulting in risk of burn injuries.
• Do not stay on the side of the boiler during the opening of
the doors and pay attention to fl ames.
• Take care of cleanness in the boiler room, ensure proper
ventilation and remove corrosive and fl ammable materials
located nearby.
• The boiler should be cleaned only when it does not work.
• Use mobile lamps supplied with a voltage lower than 24V
during works connected with servicing of the boiler.
• Take care of the good condition of the boiler and hydraulic
system.
• Take care of boiler cleanness.
4.2. Before fi rst fi ring up
Before the fi rst start-up, please check:
1. The correctness of installation and connection to electrical
system:
a. the actuator of the four-way valve (if any),
b. central heating pump, domestic hot water pump,
fl oor
pump (if any),
c. the sensor in the boiler,
d. fan,
e. feeder.
2. Heating system:
a. its tightness, whether there are no leaks of water from
the boiler or system,
b. whether the water is not frozen in the conductors and
expansion vessel,
c. whether water level and its pressure are correct and
su ffi cient (pressure gauge depending on the height of
the building should indicate from 0.8 to 1.2 bar). If the
pressure is too low, you should add water by pouring it
to the cold boiler.
3. Cleaning hole, which should be tight.
4. The correctness of boiler connection to the chimney.
5. Carry out measurements of chimney draught.