Pereko KSR Beta Pelet 16, Руководство по эксплуатации и обслуживанию

Страница: 167 / 184

31
The controller cooperates only with
servomotors of mixing valves equipped with
end switchers. Using other servomotors is
forbidden. Servomotors with full circle scope
of 30 to 255s can be used.
Connecting mixer description:
-
Connect mixer temperature sensor
- Connect electrical mixer pump
- Activate the controller and select in
service menu proper
mixer service
SERVICE SETTINGS o Mixer settings 1
Set in mixer service settings proper time of
Valve opening time (time should be written
on data plate of servomotor, i.e. 120s).
-
Connect electrical power of the controller
and activate it so the mixer pump is
working,
- Choose the direction in which servomotor
opens and closes. To do so, switch the
button to manual control and find
position in which temperature in mixer
circuit is maximal (in controller it is
position 100% ON) and value position
when temperature of mixer circuit is
minimal (in controller it is position 0%
OFF). Remember the position in order to
later verification of proper connection,
- Disconnect the electrical power to the
controller
- Connect electrical power to mixer
servomotor with the controller, according
to point 12.4 and value servomotor
producer’s documentation. Do not
confuse opening direction with closing
direction,
- Connect electrical power to the controller
and switch it into STAND-BY mode
- Check if wires for mixer opening and
closing are not swapped. Go into:
Manual control and open mixer by
selecting Mixer 1 Opening = ON . By
opening servomotor temperature on the
mixer sensor should increase. If not,
disconnect the power and swap wires.
(attention: another cause may be
incorrectly connected valve!
– check the
producer’s documentation if it is properly
connected),
- Set other parameters of the mixer
according to point 0
Calibration of valve indicator position:
Indicator of valve position is in the menu:
Information . For mixer 1 after some time it
will calibrate automatically. In order to make
the valve position indicator displaying quicker
the right value, disconnect the electrical
power of the controller, than in cover of the
controller
switch the button into
manual control. Turn the cap of the valve
into closed position, then again switch the
button in the cover into AUTO. Connect the
electrical power to the controller - %
indicator of valve opening is calibrated.
During calibration the servomotor is closed
through
valve opening time .
12.16 CIRCULAR PUMP CONNECTION
The circulation pump can be connected to
the boiler regulator after connecting
additional module C or Output H to the
regulator's executive module. You must set
the support
Output H1 or Output H2 and
H3 on Circulation pump .
12.17 STB TEMPERATURE LIMITER
CONNECTION
In order not to overheat the boiler due to the
controller breakdown it is obligatory to use
STB safety temperature limiter or any other
one suitable for given boiler. Limiter STB
should be connected to terminals 1-2. When
limiter is activated, blowing is stopped as
well as engine of fuel feeder.
Safety temperature limiter must
have nominal voltage at least
230V and should have valid
admission documents
In case of not installing the limiter terminals
1-2 are to be connected by a bridge. The
bridge must be made with insulated wire,
with diameter at least 0,75mm
2 .With
insulation which is thick enough to meet
safety standards of the boiler.
12.18 ROOM PANEL CONNECTION
It is possible to equip the controller with
room panel Room Control TOUCH, which has
following functions:
-
Room thermostat (controls up to 3
thermostats)