SmartRunner Matcher*
Product Specifications
2
018-
01
9
Parameterization and Operating Modes
The laser-line triangulation sensor can be configured or parameterized via 3 different methods.
Reading in code cards via the sensor camera
Processing configuration telegrams via the bus interface
Using the Vision Configurator software
The sensor has different operating modes, which can be activated for configuration,
presentation, or normal operation.
Runtime mode: measurement mode, sensor works as configured
Configuration mode: mode for configuring the sensor via data telegrams and via the
Vision Configurator configuration program
Code card mode: mode for configuring the sensor via Data Matrix control codes without
the assistance of a PC
Presentation mode: mode for presentation or testing without the assistance of a PC
2.2
Hazards of Laser Radiation
This section describes the contents and location of the warning label.
The sensor used corresponds to the safety standard IEC 60825-1:2007 for a laser class 1
product. In addition, the US regulation 21 CFR 1040.10 and 1040.11 is fulfilled except for
Laser Notice No. 50
dated June 24, 2007.
The warning label is fixed to the back of the housing as shown in the following figure.
Figure 2.4
Laser radiation warning message
Warning!
Class 1 laser light
The laser light can be an irritant, especially in a dark environment. Do not point lasers at
people!
Never look into the laser beam port if the sensor is operating.
Maintenance and repairs must be carried out by authorized service personnel only!
Install the device so that the warning is clearly visible and legible.
Do not remove the sensor's protective cover.
