2
018-
01
16
SmartRunner Matcher*
Installation
Mounting on the underside of the device with M4 screws: You can use the 2 threaded
sleeves to mount the housing on the underside of the device. The maximum screw-in
depth of the M4 screws is 5 mm.
Positioning the Sensor
When positioning the sensor, ensure that the camera's field of vision is not obscured by the
objects being scanned.
3.4
Electrical Connection
Connecting the Supply Voltage
The sensor is connected electrically via a
MAIN
8-pin M12 connector plug on the bottom of the
housing. The power supply and data transfer take place via this connection. To connect the
sensor, proceed as follows:
1. Plug the 8-pin M12 socket into the plug on the bottom of the housing.
2. Screw the lock nut onto the connector as far as it will go. This ensures that the power cable
cannot be pulled out inadvertently.
Tip
The corner of the housing where the
MAIN
8-pin M12 connector plug is located can be rotated.
Depending on the mounting position, you can rotate the connector plug in a different direction
to ensure simple cabling.
Figure 3.2
M12 connector plug
