SmartRunner Matcher*
Product Specifications
2
018-
01
11
Description of the LEDs
Figure 2.7
LEDs overview
Position
Designation
Function
1
Emitter optic
protective cover
Is used to protect against damage and contamination
2
Reception optic
protective cover
Is used to protect against damage and contamination
3
LEDs
The functional description for the LEDs can be found in
the table below.
4
Function keys in
Presentation mode
Function key 1: triggers an evaluation
Function key 2: when pressed and held for 2 seconds,
activates the teach-in process. When pressed and
held for longer than 2 seconds, activates Code Card
mode
Function keys in
Runtime mode
Function key 1: no function
Function key 2: when pressed and held for longer than
2 seconds, activates Code Card mode
5
Electrical Connection The sensor is connected electrically via a MAIN 8-pin M12
connector plug on the bottom of the housing. See chapter
3.4.
Note!
The function keys are only activated during a parameterizable time span after the sensor is
switched on, after which they are locked. The default value for this time span is 5 minutes.
The function keys have different functions depending on the selected operating state.
Position
Designation
Function
1
Ready (green/red)
Lights up red if there is a sensor fault
Lights up green when the sensor is ready for operation
Flashes green if the sensor is in Configuration mode
2
Match 3/4
(green/yellow)
Lights up green if the scanned profile matches the
taught-in profile 3 (MATCH 3)
Lights up yellow if the scanned profile matches the
taught-in profile 4 (MATCH 4)
2
1
5
6
7
8
4
3
