Pentair INTELLITOUCH, Руководство пользователя

Страница: 28 / 128

IntelliTouch
®
Control System User’s Guide
18
SpaCommand Ten Button Spa-Side Remote
The SpaCommand spa side remote controller can control up to ten functions including a spa temperature
adjustment. As many as four SpaCommand remotes can be installed in i5+3, i5S+3, i7+3, i9+3, i9+3S,
and i10+3D systems. The remote controller is for use with the IntelliTouch systems at the water’s edge.
Five (5) in-line buttons control up to ten (10) system functions numbered one through five from left to
right as shown (if the system allows). A label above or below the buttons identifies each circuit function.
A red status LED above and below the toggle button indicates which row (Top or Bottom) is active.
When one of the in-line buttons is pressed, an adjacent red status LED will be on light, indicating that
the circuit has been activated. The default circuits activated by each button are shown in the table below.
The remote includes an LED display shows the current spa water temperature. The spa temperature
may be increased or decreased by pressing the up or down arrow button located under the display. The
temperature display will blink while being changed. After setting the desired temperature, the display
will return to steady and show the actual temperature as it meets the set point. The temperature set by
the remote is only temporary. Any two buttons can be assigned to increase or decrease the IntelliFlo
VF or VS pump’s flow (GPM) rate or speed (RPM). Each press of the button increases or decreases the
pump’s flow rate or speed (see page 81) until the GPM or RPM is reached as specified in the IntelliFlo
menu. When the Spa mode is switched OFF, the temperature set at the Indoor Control Panel will resume
the next time the spa mode is activated (see “Spa Manual Heat” on page 77). The Spa Mode will
automatically turn off after 24 hours. For iS10 setup and configuration information, see page 30 and 81.
iS10 Spa-Side Remote Controller
Note: IntelliFlo
VF or VS pump
flow rate (GPM) or
speed (RPM) can be
controlled from any
two iS10 buttons. For
more information,
see page 81.
3 button
4 button
IntelliTouch System (adding multiple spa-side remote)
Press Down arrow
button and first button
at the same time
2 button
i5+3, i7+3, i9+3, -10+3D, SPA POOL
i5S, i9+3S
Top Row
HI-TEMP
Bottom Row
LO-TEMP
AUX 1 AUX 5
AUX 2 AUX 6
AUX 3 AUX 7
AUX 4 AUX 8