Pentair INTELLITOUCH, Руководство пользователя

Страница: 29 / 128

IntelliTouch
®
Control System User’s Guide
19
MobileTouch Wireless Controller
The MobileTouch wireless controller provides the same functionality as the IntelliTouch Indoor Control
Panel. It has an operating range of up to 300 ft. from the MobileTouch transceiver antenna (line of sight)
which is typically located near the IntelliTouch load center. The optimum wireless transmit and receive
range may be affected by physical obstructions, (especially those containing metal), weather conditions,
and geographical features.
The MobileTouch controller screen is an LCD (liquid crystal display) which can be sensitive to sunlight.
When exposed for extended periods the LCD screen will heat up and go black. If this happens, place the
remote in a shaded area and allow the screen to cool down. Do not attempt to adjust the contrast or the
screen will be unreadable when it eventually cools. When used outside,
keep the remote covered or in a shaded area. Prolonged exposure to
sunlight may permanently damage the unit.
WARNING!
Do not plug in the AC adapter to a power source
within five (5) feet of the pool and spa. Canadian installations
require a minimum of (3) meters from pool water. Do not recharge
outdoors. Only use Pentair Water Pool and Spa
®
approved AC adapter
transformer.
The MobileTouch wireless controller is water resistant and can be
exposed to temporary splashing or wet hands. However, the controller
is not intended to be submersed. Remove unit immediately if it is
dropped in the water or exposed to rain. Store the unit indoors in a dry
environment. Be sure the gold charging contacts are dry before charging.
MobileTouch Wireless Controller (Previous Model)
The previous model of the MobileTouch wireless controller and Transceiver antenna cannot be used
with the latest model of the MobileTouch wireless controller and Transceiver antenna. Both models
cannot coexist in the same IntelliTouch system.
iS4 Spa-Side Remote Controller
The iS4 Spa-Side remote controller is a double-insulated, waterproof device that is UL (1563) listed
for installation at the water’s edge. The iS4 is typically installed at the tile-line of the spa wall, or in
the deck within arm’s reach of a spa occupant. The iS4 provides remote switching of up to four control
circuits from the spa or nearby location. Use the iS4 for switching on the spa pump and heater or other
auxiliary equipment (i.e., lights, jet pump, air blower, etc.). The red LED status light glows steady when
in spa mode and flashes while the spa is heating. For iS4 button assignment information, see page 81.
iS4 Spa-Side Remote Controller
(Wall or tile mount)
iS4 Spa-Side Remote
Controller (Deck mount)
1
2
3 4
Red power LED
indicator
3 2
1
Red power LED
indicator
4
MobileTouch Wireless
Controller
Note: IntelliFlo VF or VS pump
flow rate (GPM) or speed
(RPM) can be controlled from
any two iS4 buttons. For more
information, see page 81.