Pentair INTELLITOUCH, Руководство пользователя

Страница: 72 / 128

IntelliTouch
®
Control System User’s Guide
62
IntelliFlo VF 3050 pump setup
(Continued)
Vacuum parameters
Use the Vacuum mode to clean the pool manually. To operate the pump in Vacuum mode, place the
IntelliTouch outdoor control panel in “Service Mode,” and stop the IntelliFlo pump. The pool service
person can then press the Vacuum button on the IntelliFlo pump. The pump would operate at the preset
Vacuum parameters, then the blockage alert parameter would be cleared and the pump will stop. Vacuum
mode only operates in flow control mode. Operating in Vacuum mode shuts off all of the pumps sensors.
This mode is identical to IntelliFlo “Feature 1 and 2” except that you can manually start this mode using
the Vacuum button. Safety considerations should be made when setting the Vacuum flow parameter.
CAUTION: Since vacuuming is manual work and the user will be at the pool, the “Blocked System” will be
switched off, it is important not to use any kind of automatic cleaners, (such as Kreepy Krauly, etc.) with Vacuum
mode.
To set the vacuum parameters:
1. From the main pump screen, press the left side button next to the select IntelliFlo pump.
2. On the next screen, press the left side button next to
SET PARAMETERS
then on the following
screen select
VACUUM PARAMETERS
.
3. To adjust one of the parameters, use the right button to increase and the left button to decrease the
parameter value.
Description Value
Vacuum Flow GPM (50 GPM default) 15-130 GPM
This setting sets the GPM that the pool
vacuum will use.
Vacuum Time Mins. (10 minutes default) 1-600 minutes (10 hours)
This parameter can be set from 1 to 600 minutes.
The typical setting is 10 minutes. This setting sets
the amount of time you wish to run the pool vacuum.
MENU/SETP/EQUIP/IFLO/PARAMS/VACUUM
BACK EXIT
VACUUM TIME MINS 75
VACUUM FLOW GPM 130
SAVE
Press this
button to
increase
value
Press this
button to
decrease
value
Save
button