Pentair INTELLITOUCH, Руководство пользователя

Страница: 38 / 128

IntelliTouch
®
Control System User’s Guide
28
Setting up the MobileTouch Wireless Controller
The following describes how to assign the MobileTouch wireless controller a communication address
for the first time and to add a MobileTouch controller to a system with a controller already installed.
To manually setup a MobileTouch wireless controller:
1. On the Outdoor Control Panel, press the
Reset
button.
2.
First Time MobileTouch install:
The three red
System Control LEDs will be lit (solid). Wait a few
seconds then press the
“F” Filter button
. For model i10+3 press the
“P” Pool Filter Pump
button.
Add a MobileTouch with existing MobileTouch installed:
The three red
System Control LEDs will
be lit (solid). Wait a few seconds then press the
“V” button
or
“1” button
.
3. The three red System Control LEDs and the auxiliary button LEDs
will begin cycling.
Wait until
the LEDs stop cycling.
The three System Control LEDs will start to blink on and off. The system is
ready to enable the MobileTouch wireless controller. Continue with step 4. See note on page 29 if
using MobileTouch firmware version
1.160/2.160.
Go to the Advanced screen.
4. From the MobileTouch controller Advanced
screen, press the
lower buttons 2 and 4 at the
same time
. The Service Personnel screen will
be displayed.
MENU SETUP ADVANCED
Getting There
Press button 2 and 4 at the same time
to access the Service Personnel screen
Three System
Control LEDs
Auxiliary LEDs
Reset button
F button
(i5+3, i5S+3 i7+3,
i9+3S, i9+3D)
P button (i10+3D)
Note: Press V or 1 button to add a
MobileTouch controller with existing
MobileTouch controller(s) already installed.