Pentair INTELLITOUCH, Руководство пользователя

Страница: 107 / 128

IntelliTouch
®
Control System User’s Guide
97
Erasing Outdoor Control Panel Memory (Factory Default)
The Outdoor Control Panel programmed memory can be erased and returned to the factory default
settings. System information such as feature circuit configuration, operation and display is retained at the
main Load Center Outdoor Control Panel and all Indoor Control Panels and MobileTouch controllers. If
the memory is erased in the main Outdoor Control Panel (located in the Load Center or Power Center),
system information retained in the Indoor Control Panel or MobileTouch is automatically downloaded.
This feature is important in case of accidental memory loss and to ease board replacement. If there are
multiple Expansion Center, iS10 Spa-Side remotes, or Indoor Control Panels, each one of the controllers
will need to be manually enabled (see pages 26 and 27 for details). For instructions about erasing system
memory from both the Outdoor Control Panel and Indoor Control Panel, refer to “Erasing the System
Memory,” page 87.
To reset to the factory default settings:
1. On the Outdoor Control Panel, press the
RESET
button.
2. The three red System Control LEDs are lit for about ten seconds.
3. While the red LEDs are lit, press one of the following buttons
• For models i5+3, i7+3, i9+3, i5S+3, i9+3S, and i10+3D, press button 5
.
• For models i5x, i10x, press
button 7
.
4. The System Control LEDs will switch off then on completing a normal system restart. Wait until the
system has returned to “AUTO” and “POOL” modes before resuming operation.
Main Outdoor Control Panel in the Load Center or Power Center
LEDs (System Control)
Reset button
5 button
(i5+3, i7+3, i9+3,
i5S+3, i9+3S,
i10+3D)
7 button
(i5, i10x)