Connecting the cables
32
Model 1001MC Operations Guide
2 • Hardware installation
Connecting the cables
Installing 1001MC rear I/O card cables takes place in the following order:
1.
Installing the 10Base-T Ethernet cable onto the 10Base-T port (see
figure 9
) (see
“Installing the Ethernet
cable”
on page 32).
2.
Installing the cable onto the RS-232 configuration/daisy-chain port (see
figure 9
) (see
“Installing the RS-
232 configuration/daisy-chain port cable”
on page 34).
Figure 9. Rear I/O card ports
Installing the Ethernet cable
The RJ-45 Ethernet jack on the rear I/O card of the Model 1001MC is designed to connect directly to a
10Base-T network.
Figure 10
shows the RJ-45 jack pin-out diagram. Refer to the following sections when con-
structing Ethernet cables to connect to the Patton Model 1001MC.
Figure 10. 1001MC 10Base-T Ethernet port pin-out diagram
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Содержание NetLink 1001MC
Страница 10: ...10 Chapter 1 Introduction Chapter contents Introduction 11 Model 1001MC management overview 14...
Страница 43: ...Saving HTTP HTML object changes 43 Model 1001MC Operations Guide 3 Getting started Figure 18 1001MC command map...
Страница 232: ...About 1001MC 232 Model 1001MC Operations Guide 10 HTTP HTML web page reference Figure 113 System Level Information page...