OPERATOR’S SECTION
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
31
boom foot pivot pin enter the value as a negative by using the arrows “UP or DOWN”
to adjust the display. Press “OK” to enter measurement.
4.7. CONFIG MAIN BOOM - This section configures the type of main boom, select fixed. Press
the “OK” button and proceed by answering the questions on the screen.
4.7.1. MAIN BOOM FIXED? - Press “OK” to accept. Enter boom length as the minimum and
maximum value.
4.7.1.1. Enter the minimum length using the arrows “UP or DOWN” to adjust the
display. Press “OK” to enter length.
4.7.1.2. Enter the maximum length using the arrows “UP or DOWN” to adjust the
display. Press “OK” to enter length.
4.8. CONFIG EXTENSION - This section configures two extensions with minimum and maximum
length. Use figures 4 and 5 to help identify your configuration. Press “OK” and proceed by
entering extension lengths, and angle. Configure the extensions that your crane will use and
enter zero for unused portions of CONFIG EXTENSION. Recommendation: setup the
extensions minimum length as zero, so if this extension is removed you can change the
length in the SELECT section of operation instead of entering calibration mode to remove
extension.
Figure 4. Jib Extension
Enter extension as length minimum and
maximum
Figure 5. Jib Extension - Offset
Enter extension as length minimum and
maximum and angle offset minimum and
maximum
4.8.1. LENGTH_1 MIN - Press the arrows “UP or “DOWN” to display minimum length. Press
“OK” to enter length. (See Table 1 in Section 3.2.D Length 1 Min)
4.8.2. LENGTH_1 MAX - Press the arrows “UP or “DOWN” to display maximum length.
Press “OK” to enter length. (See Table 1 in Section 3.2.D Length 1 Max)
4.8.3. LENGTH_2 MIN - Press the arrows “UP or “DOWN” to display “0”. Press “OK” to
enter length.
JIB LENGTH
JIB LENGTH
JIB ANGLE
