EI65 OPERATOR’S AND CALIBRATION MANUAL
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
12
Push Button “OK” (10) for next step.
If the operator wants to continue with the previously programmed or default number of
reevings he has to push button “DOWN” (11). Step 13 will be skipped, when the button
“DOWN” is pressed.
STEP 13
The display shows the previously programmed or default number of reevings (parts of line).
To enter a new number of reevings the operator has to select the value by pushing the
buttons “UP” (12) or “DOWN” (11).
If the operator wants to continue with the displayed number of reevings (parts of line) he has
to confirm by pushing the button “OK” (10).
Push Button “OK” (10) for next step.
STEP 14
The Setting Procedure is completed. The crane operator has the possibility to accept the
conditions programmed on Step 1 to 12, or to correct the values.
For correction of the preset conditions the Button “DOWN” (11) has to be pushed. In this
case the system starts again the Startup Procedure.
If the displayed conditions are O.K. the crane operator has to push Button “OK” (10).
Then the display will show the actual crane data.
Setting of Reevings
The setting procedure can be activated by the operator by pushing the button “Reevings/Hoist
Winch” (7).
After pushing the button one time an asterisk will appear on the display beside the
number of reevings, indicating that the procedure of setting the reevings is
activated. To enter a new number of reevings the operator has to select the value
by pushing the buttons “UP” (12) or “DOWN” (11).
If the operator wants to continue with the displayed number of reevings (parts of
line) he has to confirm by pushing the button “OK” (10).
After pushing the button “OK” (10) the procedure for Number of Reevings is completed and
the display will show the actual crane data.
4.2.2 Selecting the Hoist Winch
The procedure for selecting the hoist winch can be activated by the operator by pushing the
button “Reevings/Hoist Winch” (7) two times.
16
*
