Parker VitaPump, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 45

17
3.0 Back Panel: Interface Options
The VitaPump back panel provides interfacing ports for:

Printer Port: The VitaPump can be connected to a PC for data collection or to a Parker
Printer via the female DB9 RS-232 port labeled “Printer”. You need a Parker RS-232 cable
(P/N 080-073) to connect to a PC for data archival, or a printer cable (080-096) to make the
connection between the printer and the VitaPump.

Electronic Balance: Male DB9, labeled “S1”. (S2 and S3 are not utilized.)

Alarm / Remote Start – Stop Cable Set: (PN 080-074) Male DB37, Labeled “External I/O”.
See explanation on the next page.

SciPres Disposable Pressure Sensors: Three RJ11 telephone jacks, one for each
pressure sensor. Labeled “P1, P2, P3”. Not utilized by the VitaPump.

SciTemp Disposable Temperature Sensor: Conxall 2 pin connector. Labeled
“Temperature” Not utilized by the VitaPump

Scale Ports: The male DB9 ports labeled “S1”, “S2” and “S3” are RS-232 ports for
electronic scales. For the VitaPump, only S1 is used. This port allows the user to interface
with a number of different electronic scales: i.e. Mettler, Ohaus, and Sartorius top-loading
scales. The following scale cables are required:
Mettler ICS425 Series: PN: 080-072ICS
Mettler: PGS, PM, Viper Models P/N: 080-067PGS
Ohaus: Adventurer (Pro) Series P/N: 080-067PGS
Sartorius: Most Series Balances P/N: 080-068

In VitaPump: Setup: Scale, select the scale manufacturer; the VitaPump will automatically
implement the correct communications parameters. Check that the proper
communications parameters are also implemented in the scale being used.

Valve V Port: not utilized by the VitaPump.