Parker PAC, Руководство по установке, Страница: 172 / 197

COMMUNICATIONS MODULES
172 Parker Automation Controller Installation Guide
Removal
1. Remove power from the PAC Controller.
2. To unlock the Communications Module, pull the
handle of the sliding latch out of the module.
3. While holding on to the handle of the sliding
latch, pull the Module fully out of the housing of
the Controller. A little strength may be required
to overcome the resistance of the brackets
clamping onto the internal carrier board.
Configuration of PROFINET Communications
Module
This section describes a step-by-step instruction on connectivity of a PAC to a Siemens S7 controller
communicating PROFINET by way of the PROFINET communication module.
Hardware:

PAC320 with PROFINET Module

Siemens CPU315-2 PN/DP
Software:

Parker Automation Manager

Siemens S7 315-2 PN/DP
Parker Automation Manager Configuration
1. Open Parker Automation Manager and select File / New Project.
2. Select the Empty Project template and choose OK.
3. Select File / Save Project As PROFINET .
4. Right-click on the new name in the tree and select Add Device.
5. On the menu that appears, select the pulldown next to Vendor and choose .
6. Add Device, then Close.
7. Right-click on Application, select Add Object and choose POU.
8. Name the POU PLC_PRG, create this to be a Program and use the Ladder Logic Diagram (LD).
9. Choose
10. Right-click on Task Configuration.