Parker PAC, Руководство по установке, Страница: 119 / 197

Mounting 35mm DIN-Rail
Controller ASIC ET1200
E-Bus Load 300mA
Connector IO/Power Plug 36-pole (43-026592-01)
Power 24V DC -20% +25%
Galvanic separation Separated from one another and versus the bus
Storage temperature -
Operating temperature
Relative humidity 5%...95% without dewing
Protection IP20
Interference immunity Zone B
Terminals
Pin Signal Explanation
0 In_0 Digital Input 0
1 In_1 Digital Input_1
2 In_2 Digital Input 2
3 In_3 Digital Input 3
4 Out_0 Digital Output
5 A_Out+ Analog
6 A_Out- Analog Output -
7 A+ Encoder signal A+ *
8 A- Encoder signal A- *
9 B+ Encoder signal B+ *
10 B- Encoder signal B- *
11 Ref+ Encoder Ref *
12 Ref- Encoder Reference - *
13 5 VDC Encoder supply 5V (0.2A fuse)
14 0 VDC Encoder supply 0V
15 n. c. Not recommended for use
16 24 VDC 24 VDC supply
17 0 VDC 0 VDC Supply
* Unused encoder signals should be pulled up to +5V
The PACIO Counter/Enc Module has two identical channels with the same connections listed in the above
table.
The Controller and I/O modules have been tested to comply with international electromagnetic and
emission standards. To reduce radiated emissions, ensure that there is a good earth connection to the
PAC, which can be accomplished by attaching the DIN rail to a suitable Earth ground and also utilizing
Pin-3 on the Controller DC power input connector. This connection must be made with the shortest
possible, heavy gage wire or braided cable. Low-resistance (<0.5 ohms) continuity should be verified with
an ohmmeter for proper grounding. In addition, all communication cables should be shielded and