2000-A2-GB20-10
- 78 -
February 2004
7. The IAD saves the configuration and displays the PVC Configuration
menu where you may continue with other PVC management tasks.
8. Reset the IAD (page
14
) when you finish PVC configuration.
Modifying a PVC
To modify a PVC, follow these steps:
1. On the ATM PVC Configuration menu, type
2
to select Modify Existing
PVC.
2. The IAD displays the following port table, and a prompt:
Port VPI
VCI
Encapsulation Type
PCR
Service
1
0
40
RFC 1483 (with LLC Encapsulation) 3641
UBR
2
100 39
RFC 1483 (with LLC Encapsulation
4
CBR
--------
Total = 3645 cps
Maximum PCR this interface can support = 4830 cps
Select Port: [1-8]
Type the port number and press Enter.
3. The IAD displays a prompt for the VPI:
Enter Virtual Port Identifier (VPI):
Type a VPI value between 0 and 255 (default 0) and press Enter.
4. The IAD displays a prompt for the VCI:
Enter Virtual Circuit Identifier (VPI):
Type a VCI value between 32 and 65535 (the default is 38 for data and
39 for voice) and press Enter.
5. The IAD displays the ATM Encapsulation Configuration menu.
Figure 4–40. ATM Encapsulation Configuration Menu
Select the encapsulation you want to assign to this PVC. Proceed to the
corresponding section and perform the steps to set up the encapsulation
you’ve chosen.
Setting up AAL5 or AAL0 Encapsulation
1. Type
1
to select AAL5, or type
2
to select AAL0 encapsulation.
2. The IAD displays the ATM Service Category Configuration menu:
*****************************************
ATM Encapsulation Configuration
*****************************************
Current Encapsulation: NONE
1. AAL5 (None)
2. AAL0 (None)
3. Proprietary Voice
4. RFC 1483 (using VC Muxing)
5. RFC 1483 (with LLC Encapsulation)
6. RFC 2364 (PPPoATM with LLC Encapsulation)
7. RFC 2364 (PPPoATM using VC Muxing)
8. AAL1/CES
9. AAL2 (LES, NBT)
