2000-A2-GB20-10
- 84 -
February 2004
To delete the PVC, type
Y
, or cancel the deletion by typing any other
character.
3. The IAD saves the configuration and displays the PVC Configuration
menu where you may continue with other PVC management tasks.
4. Reset the IAD (page
14
) when you finish PVC configuration.
Showing Current PVCs
To display a list of current PVCs, type
4
.
The IAD displays the port list with associated PVCs:
Port VPI
VCI
Encapsulation Type
PCR
Service
1
0
40
RFC 1483 (with LLC Encapsulation) 3641
UBR
2
100 39
RFC 1483 (with LLC Encapsulation
4
CBR
--------
Total = 3645 cps
Maximum PCR this interface can support = 4830 cps
When you’re done viewing the list, press any key to return to the ATM PVC
Configuration menu.
Configuring
ATM
Options
To configure ATM options, type
4
to display the ATM Configuration menu:
Figure 4–54. ATM Configuration Menu
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the ATM
Configuration menu.
Configuring Payload Scrambling (following)
Configuring F4 OAM VPI (page
85
)
Configuring F4 OAM Type (page
85
)
Displaying F4 OAM Configuration (page
86
)
Sending OAM Loopback (page
86
)
Configuring EmptyCells (page
86
)
Configuring Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling.
To enable or disable payload scrambling:
*****************************************
ATM Config Menu
*****************************************
1. Configure Payload Scrambling
2. Configure F4 OAM VPI
3. Configure F4 OAM Type
4. Display F4 OAM Configuration
5. Send OAM Loopback
6. Configure EmptyCells
