2000-A2-GB20-10
- 90 -
February 2004
16. If you type 2, the IAD displays the fragment size prompt:
Enter maximum fragment size in bytes (100-1600) [0]:
Type the fragment size in bytes and press Enter.
17. The IAD displays the End-to-End Fragmentation Configuration menu.
Press Escape to return to the FR DLCI Config menu.
18. Reset the IAD (page
14
) when you finish DLCI configuration.
Deleting a DLCI
To delete a DLCI:
1. On the Frame Relay DLCI Configuration menu, type
3
to select Delete
DLCI.
2. The IAD displays the port list and prompt:
Port
DLCI
Encapsulation
1
16
RAW (No Encapsulation)
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to delete.
a. To permanently remove the DLCI configuration, type
y
.
b. To cancel the operation, type
n
.
3. Reset the IAD (page
14
) when you finish DLCI configuration.
Displaying Current DLCIs
To display a list of the current DLCIs, type
4
on the Frame Relay DLCI
Configuration menu.
The IAD displays the port list:
Port DLCI Encapsulation
---- ----- -------------
1 16 RAW (No Encapsulation)
4. Press any key to display the Frame Relay DLCI Configuration menu.
Configuring
Frame
Relay
Options
To configure Frame Relay options, type
4
on the WAN Configuration
menu. The IAD displays the Frame Relay menu:
Figure 4–60. Frame Relay Options Menu
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the Frame
Relay Options menu.
Configuring Fragmentation (following)
*****************************************
Frame Relay Options
*****************************************
1. Configure Fragmentation
2. Configure Maintenance Protocol
3. Configure Congestion Parameters
4. Enable/Disable Coppermountain CMCP
