2000-A2-GB20-10
- 48 -
February 2004
This chapter describes how to configure the IAD WAN interface and
datalink protocol for data operation.
Basic WAN setup tasks (page
48
)
Using the WAN Configuration menu (page
52
)
Selecting the Datalink Protocol (page
53
)
Selecting the Physical Interface (page
55
)
Configuring the G.SHDSL Interface (page
56
)
Configuring the SDSL Interface (page
60
)
Configuring the ADSL Interface (page
64
)
Setting the Interface to T1 or E1 (page
65
)
Configuring the T1 Interface (page
66
)
Configuring the E1 Interface (page
71
)
Configuring ATM PVCs (page
75
)
Configuring ATM Options (page
84
)
Configuring Frame Relay DLCIs (page
86
)
Configuring Frame Relay Options (page
90
)
Using the Quick Configure Option (page
95
)
Basic WAN
Setup
Tasks
To set up the IAD for voice and data operation, you must perform at least
these basic tasks:
Select ATM or Frame Relay as the datalink protocol (page
53
)
For ATM protocol, configure ATM PVCs (page
75
) and ATM options
(page
84
)
For Frame Relay protocol, configure Frame Relay DLCIs (page
86
)
and Configure Frame Relay options (page
90
)
Configure the WAN interface for your IAD (following)
For channelized T1, set up voice and data circuits (page
54
)
Configure the voice path (
Voice Path Configuration
on page
127
).
Use the flowcharts below to plan your tasks for configuring either xDSL or
T1/E1 based on your wide area networking requirements.
:$1&RQILJXUDWLRQ
NOTE
When the IAD prompts you for input, it displays the default or
current value in parentheses. To conveniently accept this
value, just press Enter.
