2000-A2-GB20-10
- 75 -
February 2004
Displaying Physical Layer Stats and Alarm Log
1. Type
P
to display the physical layer statistics and the alarm log:
Error Count Rates (Errors/s):
Framing Bit Error Count Rate: 4000
CRC Error Count Rate: 0
Line Code Violation Count Rate: 0
Far End Block Error Count Rate: 1000
Rx Loss of Frame Count Rate: 0
Change Of Frame Alignment Rate: 0
Severely Errored Frame Rate: 3
ALARM LOG (Last 10 Items):
Current Time is 1:1:5
elapsed time alarm
------------ ------
0:0:10
RALOS RLOS RLOF SIGFRZ
Enter any key to continue paging through the report; press Escape to
cancel and return to the menu.
Configuring
ATM PVCs
You may configure up to 8 ATM PVCs on the IAD. To configure create and
manage PVCs, type
3
on the WAN configuration menu. The IAD displays
the ATM PVC Configuration menu:
Figure 4–36. ATM PVC Configuration Menu
Type the option to perform a task. Proceed to the corresponding section.
Adding a New PVC (page
75
)
Modifying an Existing PVC (page
78
)
Deleting an existing PVC (page
83
)
Displaying the Current PVCs (page
84
)
Adding a PVC
To add a PVC, follow these steps:
1. On the ATM PVC Configuration menu, type
1
to select Add New PVC.
2. The IAD displays a prompt for the VPI:
*****************************************
ATM PVC Config Menu
*****************************************
1. Add New PVC
2. Modify Existing PVC
3. Delete PVC
4. Show Current PVCs
NOTE
Before you configure PVCs, you must first set the datalink
protocol to ATM. If option 3 on the WAN Configuration menu
displays Configure DLCIs instead of Configure PVCs, it is
because your datalink protocol is set to Frame Relay instead
of ATM.
