2000-A2-GB20-10
- 127 -
February 2004
After you have defined the voice PVCs or DLCIs on the IAD, you should
configure the voice path for voice operation to function correctly.
This chapter contains the following topics:
Basic Voice Path Setup Tasks (page
127
)
Voice Path Configuration Menu (page
127
)
Setting the Voice Gateway (page
128
)
Setting Jitter Delay (page
130
)
Setting Start Mode (page
130
)
Setting SLIC Control Mode (page
132
)
Setting Compander Mode (page
132
)
Setting On Hook Transmission Mode (page
133
)
Setting Idle Voltage Mode (page
133
)
Setting Debug Mode (page
134
)
Configuring Echo Cancellation (page
134
)
Setting Loop Gain (page
135
)
Setting Country Mode (page
137
)
Basic Voice
Path Setup
Tasks
To configure voice path settings, you should complete the following tasks:
Select a voice gateway (page
128
)
Set the jitter delay (page
130
)
Set start mode (page
130
)
Set Compander mode (page
132
)
Set echo cancellation (page
134
)
Set loop gain (page
135
)
Set bandwidth tone (page
137
)
9RLFH3DWK
&RQILJXUDWLRQ
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.
