2000-A2-GB20-10
- 110 -
February 2004
Figure 5–6. IP Filtering Configuration Menu
Each of the tasks in this section originate at the IP Filtering Configuration
menu. Type the option for the task to perform and proceed to the
corresponding section.
Choosing a Port for IP Filtering
To set the port on which to use IP filtering, follow these steps:
1. On the IP Filtering Configuration menu, type
P
to select Choose Port
for IP Filtering.
2. If more than one WAN port is installed or more than one PVC/DLCI
exists, the IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:
1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)
Type the interface number to set.
3. The IAD displays the port table for this interface and prompts for a port:
Port VPI VCI Encapsulation Type
PCR
Service
1
0
40 RFC 1483 (with LLC Encap)3641
UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to set for IP filtering and press Enter.
4. The IAD saves the changes and displays the Router Configuration
menu.
*******************************************
IP Filtering Configuration Menu
*******************************************
Editing Unselected Port Input filters
P. Choose port for IP filtering
F. Globally enable/disable input or output filters
T. Toggle input or output type filters to view/edit
D. Display all filters of the chosen type
I. Insert new or buffered filter of chosen type
A. Append new or buffered filter to end of list
E. Edit a filter of the chosen type
C. Copy filter operations menu
X. Delete one filter of the chosen type
Z. Delete all filters of the chosen type
S. Show IP filtering statistics
Y. Clear IP filtering statistics
Status
Messages
for IP
Filtering
display
here
NOTE
Directly below the banner on the IP Filtering Configuration
menu is a message line. The IAD uses the message line to
alert you that you are working with the input or output filters.
To toggle between them, use option T, Toggle input or output
type filters to view/edit.
