Panasonic ZEQUO 2200, Руководство по эксплуатации

Страница: 465 / 726

50. QoS Commands
465

Restrictions
None.

Example
To display the port bandwidth control table for ports 1 to 2:
50.3. config per_queue bandwidth_control
 Description
This command is used to set the bandwidth control for each specific egress queue on
specified ports. The maximum rate limits the bandwidth. When specified, packets
transmitted from the queue will not exceed the specified limit even if extra
bandwidth is available. The specification of maximum rate is effective regardless of
whether the queue is operating in strict or Shaped Deficit Weighted Round Robin
(SDWRR) mode.

Format
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list 0-7>
{{min_rate [no_limit | <value 64-10240000>]} max_rate [no_limit | <value 64-
10240000>]}(1)

Parameters
Zxxx0:admin#show bandwidth_control 1-2
Command: show bandwidth_control 1-2
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
---- ---------- ---------- ---------------- ----------------
1 No Limit No Limit No Limit No Limit
2 No Limit No Limit No Limit No Limit
Zxxx0:admin#
ports (Optional) Specify a range of ports to be configured.
<portlist>
Specify a range of ports to be configured.
all Specify to set all ports in the system. If no parameter is specified, the system will set
all the ports.
<cos_id_list 0-7>
Specify a list of priority queues. The priority queue number ranges from 0 to 7.