Panasonic ZEQUO 2200, Руководство по эксплуатации

Страница: 373 / 726

41. MLD Snooping Commands
373
To display the MLD snooping packet rate limit for ports 1 to 2:
41.4. create mld_snooping static_group

Description
This command is used to create an MLD snooping multicast static group. Member ports
can be added to the static group. The static member and the dynamic member port form
the member ports of a group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For
those static member ports, the device needs to emulate the MLD protocol operation to the
querier, and forward the traffic destined to the multicast group to the member ports. For a
layer 3 device, the device is also responsible to route the packet destined for this specific
group to static member ports. The static member port will only affect V2 MLD operation.
The Reserved IP multicast addresses FF0x::/16 must be excluded from the configured
group. The VLAN must be created first before a static group can be created.
 Format
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create an MLD snooping static group on vlan1, group FF1E::1:
Zxxx0:admin#show mld_snooping rate_limit ports 1-2
Command: show mld_snooping rate_limit ports 1-2
Port Rate Limit
-------- ------------
1
No Limit
2 No Limit
Total Entries: 2
Zxxx0:admin#
vlan Specify the name of the VLAN on which the static group resides.
<vlan_name 32>
Specify the VLAN name. The maximum length is 32 characters.
vlanid Specify the VLAN ID list.
<vlanid_list>
Specify the VLAN ID list.
<ipv6addr>
Specify the multicast group IPv6 address.