Panasonic PT-MZ770, Инструкция по эксплуатации (Функциональное руководство)

Страница: 128 / 233

Chapter 4 Settings — [PROJECTOR SETUP] menu
128 - ENGLISH
f
The [PROJECTOR SETUP] menu → [DATA CLONING] → [LAN] → [WRITE PROTECT] → [OFF]
1) Connect all projectors to the hub using LAN cables. (
x
page 155)
2) Turn on all the projectors.
3) On the copy source projector, press
as
to select [DATA CLONING].
4) Press the <ENTER> button.
f
The [SECURITY PASSWORD] screen is displayed.
5) Enter a security password and press the <ENTER> button.
f
The [DATA CLONING] screen is displayed.
6) Press
as
to select [LAN].
7) Press the <ENTER> button.
f
The [LAN DATA CLONING] screen is displayed.
8) Press
as
to select [SELECT PROJECTOR].
9) Press the <ENTER> button.
f
The projector in the same subnet is displayed as a list.
10) Press
as
to select the copy destination projector.
11) Press the <ENTER> button.
f
To select multiple projectors, repeat Steps 10) to 11) .
12) Press the <DEFAULT> button on the remote control.
f
The confirmation screen is displayed.
13) Press
qw
to select [OK], and press the <ENTER> button.
f
Copy of the data between the projectors is started.
Once the copy is completed, the cloning result is displayed as a list in the
[LAN DATA CLONING] screen.
Meanings of the marks displayed in the list are as follows.
g
Green: Data copy has succeeded.
g
Red: Data copy has failed. Confirm the connection of the LAN cable and power status of the copy
destination projector.
f
After displaying the LAN data cloning request message, the destination projector automatically shifts to the
standby state and performs the copy of the data.
14) Turn on the power of the copy destination projector.
f
The copied content is reflected on the copy destination projector.
Note
f
The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
f
While data is being copied, the light source indicator <LIGHT>, the temperature indicator <TEMP>, and the filter indicator <FILTER> of the
destination projector will blink. Make sure that the indicators stop blinking before powering on the projector.
Setting [WRITE PROTECT]
Set if the copy of data via LAN is permitted or not.
1) On the copy destination projector, press
as
to select [DATA CLONING].
2) Press the <ENTER> button.
f
The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The [DATA CLONING] screen is displayed.
4) Press
as
to select [LAN].