Panasonic PT-MZ570, Руководство по эксплуатации

Страница: 30 / 229

Chapter 1 Preparation — About your projector
30 - ENGLISH
25 Remote control wired terminal
This is a terminal used to connect to the projector via a cable
when the remote control is used as a wired remote control.
(
x
page 34)
Attention
f
Do not drop the remote control.
f
Avoid contact with liquids or moisture.
f
Do not attempt to modify or disassemble the remote control.
f
Observe the following instructions that are indicated on the caution label at the back of the remote control:
g
Do not use old battery with new one.
g
Do not use batteries other than the type specified.
g
Be sure the batteries are inserted properly.
For other instructions, read the instructions related to batteries that are described in “Read this first!”.
Caution label at the back of the remote control
Note
f
When operating the remote control by directly pointing at the remote control signal receiver of the projector, operate the remote control
within a distance approximately 30 m (98'5") from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f
The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f
If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f
The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.