Panasonic PT-MZ570, Руководство по эксплуатации

Страница: 114 / 229

Chapter 4 Settings — [PROJECTOR SETUP] menu
114 - ENGLISH
[ECO MANAGEMENT]
Set [ECO MANAGEMENT] to reduce the power consumption and enhance the life of the light source.
Setting [LIGHT POWER]
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [LIGHT POWER].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Set this item when high luminance is required. The light power is 100 % and the estimated runtime is
approximately 20 000 hours
*1
.
[ECO]
The luminance will decrease compared to [NORMAL], but set this item to suppress the reduction in
luminance against the runtime of the light source. The light power is 70 % and the estimated runtime
is approximately 24 000 hours
*1
.
[QUIET]
Select this item to prioritize the operation with low noise. The light power is 70 % and the estimated
runtime is approximately 20 000 hours
*1
.
*1 The runtime is an estimation when the [PICTURE] menu → [DYNAMIC CONTRAST] is set to [2].
Note
f
Under influences of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f
Runtime is a time until the luminance of the light source to become about half when using the projector continuously. The runtime is just an
estimate, and is not the warranty period.
f
If the runtime exceeds 10 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
f
When anything other than [NORMAL] is set, the setting in the [PROJECTOR SETUP] menu → [LightID] is disabled, and this item is fixed to
[OFF].
Setting [AMBIENT LIGHT DETECTION]
Sets if the [AMBIENT LIGHT DETECTION] function to adjust the light power depending on the brightness of the
installed location is enabled or not.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [AMBIENT LIGHT DETECTION].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the ambient light detection function.
[ON] Enables the ambient light detection function.
Note
f
The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such a
case, it may not operate properly even if [AMBIENT LIGHT DETECTION] is set to [ON].
f
When the [PROJECTOR SETUP] menu → [LightID] is set to [EXTERNAL CONTROL] or [INTERNAL ID], [AMBIENT LIGHT DETECTION] is
set to [OFF].
Setting [SIGNAL DETECTION]
Set if the [SIGNAL DETECTION] function to reduce the power of the light source during no signal is enabled or
not.
1) Press
as
to select [ECO MANAGEMENT].