Panasonic PT-MZ570, Руководство по эксплуатации

Страница: 126 / 229

Chapter 4 Settings — [PROJECTOR SETUP] menu
126 - ENGLISH
[DC OUT]
Set the power supply function of the <DC OUT> terminal.
1) Press
as
to select [DC OUT].
2) Press
qw
to select an item.
[ON]
Enables the power supply function. Power is supplied to the external device connected to the <DC
OUT> terminal.
[OFF]
Disables the power supply function. The power is not supplied even if an external device is connected
to the <DC OUT> terminal.
Note
f
When [DC OUT] is set to [ON], the power is supplied even in the standby state or ready state in the following cases.
g
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], and [QUICK STARTUP] is
set to [ON], and then the projector goes into the standby state by pressing the power <
v
/
b
> button
g
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER MANAGEMENT] is set to [READY], and no signal is
detected and the projector goes into the ready state
f
When an external device exceeding the rating (DC 5 V, maximum 2 A) is connected to the <DC OUT> terminal while this function is set to
[ON], an error is detected and the power supply will be stopped. At this time, [ERROR] is displayed in [DC OUT]. Disconnect the external
drive and turn on the projector again when [ERROR] is displayed.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The [STATUS] screen is displayed.
3) Press
qw
to switch the pages.
f
The page will change each time you press the button.
[PROJECTOR TYPE] Displays the projector type and serial number of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
[MAIN/SUB VERSION] Displays the main and sub versions of the firmware of the projector.
[NETWORK VERSION] Displays the network version of the firmware of the projector.
[INTAKE AIR TEMP.]
*1
Displays the status of the intake air temperature of the projector.
[EXHAUST AIR TEMP.]
*1
Displays the status of the exhaust air temperature of the projector.
[LIGHT TEMP. 1]
*1
Displays the temperature status for the front block of the light source (on the lens side).
[LIGHT TEMP. 2]
*1
Displays the temperature status for the rear block of the light source (on the air exhaust port side).
[SELF TEST] Displays the status of the projector.
[INPUT] Displays the input terminal currently selected.
[SIGNAL NAME] Displays the input signal name.
[MEMORY NO.] Displays the memory number of the input signal.
[ON COUNT] [POWER ON TIMES] Displays the number of times the power is turned on.
[NUMBER OF REGISTERED
SIGNAL]
Displays the number of registered signals.
[COOLING CONDITION] Displays the set cooling conditions.
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[REMOTE1 STATUS] Displays the control status of the REMOTE1.
[EMULATE]
Displays the setting in the [PROJECTOR SETUP] menu → [RS-232C] → [EMULATE].