Technical Information
78
- ENGLISH
Appendix
J
Basic format
Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.
STX
A D
I 1
I 2
;
C1 C2 C3
:
P1 P2
Pn
ETX
When sending commands without parameters, a colon (:) is not necessary.
:
½
J
Basic format (with sub command)
STX
A D
I 1
I 2
;
C1 C2 C3
:
ETX
S1
S2
S3
S4
S5
E
P1
P2
P3
P4
P5
P6
When transmitting a command which does not need a parameter, the operation (E) and parameter are not
:
½
necessary.
Attention
No command can be sent or received for 60 seconds after the lamp starts lighting. Try sending any command after that
z
period has elapsed.
When transmitting multiple commands, be sure to wait until 0.5 seconds has elapsed after receiving the response from the
z
projector before sending the next command.
Note
As with the PT-F300U/PT-FW300U and similar models, formats without an ID designation can also be used.
z
When the command can not be executed, the [ER401] status is sent from the projector to the personal computer.
z
When the wrong parameter is sent, the [ER402] status is sent from the projector to the personal computer.
z
Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.
z
If a command is sent with a projector ID specified, the projector will return answer back only in the following cases:
z
If it coincides with the projector ID
If the ID specification is ALL and responding (ID ALL) is [ON]
The “STX” character code is 02 and the “ETX” character code is 03.
z
End
(1 byte)
Parameter
(undefined length)
Colon
(1 byte)
3 command
characters
(3 bytes)
Semicolon
(1 byte)
2 ID
characters
(2 bytes)
ID designate
ZZ, 1 to 64 and 0A to 0Z
(2 bytes)
Start
(1 byte)
Parameter (6 bytes)
Symbol “+” or “-” (1 byte) and set value or
adjustment value (5 bytes)
Operation (1 byte)
“=” (Value specified using parameter is set)
Same as basic format
Sub command (5 bytes)
