9-4. Setting Reset Function
This function will cause all settings to revert to factory settings. However, any settings that have been saved
within the data bank will not be changed.
If the information stored within the data bank is to be changed, then data bank settings must be overwritten with
new settings by using the ‘7-3. Data Bank Save Function’ from ‘PRO3 Mode’, described on p. 40.
Press the
MODE key 5 times.
Turn the Jog switch 5 times
toward the ‘
’ direction.
Press the
Jog switch.
Turn the Jog switch twice
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
1
Press the [MODE key] 5 times to select ‘PRO mode’.
2
Turn the [Jog switch] 5 times toward the ‘
’ direction, to
select ‘PRO5 mode’.
3
Press the [Jog switch] to enter the ‘code setting’ state.
4
Turn the [Jog switch] twice toward the ‘
’ direction, to enter
the ‘reset setting’ state.
5
If the [Jog switch] is pressed, the letters ‘ ’ (red) will be
displayed.
5
If the [Jog switch] is pressed, the letters ‘ ’ (red) will quickly
blink to reset all setting to factory setting.
After that, the amplifier will automatically return to ‘RUN
mode’ (normal sensing operation).
50
Ramco National
(800) 280-6933
www.panasonicsensors.com
