9-2. Code Setting Function
The input of a 8-digit code allows the configuration to be set directly, without the need to set each individual
function.
Press the
MODE key 5 times.
Turn the Jog switch 5 times
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Select the desired code
by turning the Jog switch.
(Repeat this motion 8 times.)
Confirm the
selection
by pressing
the Jog switch.
Press the
MODE key once.
Press the
MODE key once.
The digital display will quickly
blink to confirm the setting.
1
Press the [MODE key] 5 times to select ‘PRO mode’.
3
Press the [Jog switch] to enter the ‘code setting’ state.
5
If the [Jog switch] is pressed, the first green digit will blink.
6
Repeat the following motions: select the code by turning the
[Jog switch], then confirm each selection by pressing the
[Jog switch].
Once 8-digit have been input, the digital display (green and
red) will quickly blink, confirming the ‘code’ setting.
The digital display will not blink (green and red) if the
setting has not been changed.
Refer to the ‘Code Setting Table’ on p. 46 for code setting.
2
Turn the [Jog switch] 5 times toward the ‘
’ direction, to
select ‘PRO5 mode’.
7
If the [MODE key] is pressed once, the amplifier will return to
‘PRO5 mode’.
8
Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
4
If the [Jog switch] is pressed, the current setting will be
displayed.
* The factory setting is ‘ ’.
48
Ramco National
(800) 280-6933
www.panasonicsensors.com
