8-3. Selection for Transmission Change to Permit / Not to Permit
When attempting to perform single step load / save / copy operations using the setting condition data bank load
function and data bank save function from PRO3 mode, and copy function from PRO4 mode, if the transmission
change has not been permitted, then only the specified amplifier will be locked. Therefore single step load / save /
copy operations will be disabled.
Lock OFF
(Permit)
Lock ON
(Not permit)
Press the
MODE key 5 times.
Turn the Jog switch 4 times
toward the ‘
’ direction.
Press the
Jog switch.
Press the
Jog switch.
Press the
Jog switch.
Turn the Jog switch once
toward the ‘
’ direction.
Press the
MODE key once.
Press the
MODE key once.
The digital display will quickly
blink to confirm the setting.
Select from Lock ON / Lock OFF
by turning the Jog switch.
1
Press the [MODE key] 5 times to select ‘PRO mode’.
3
Press the [Jog switch] to enter the ‘copy setting’ state.
4
Turn the [Jog switch] once toward the ‘
’ direction, to enter
the ‘selection for transmission change to permit / not to
permit’ state.
5
If the [Jog switch] is pressed, the current setting (red) will be
displayed.
* The factory setting is ‘Lock OFF (permit)’.
2
Turn the [Jog switch] 4 times toward the ‘
’ direction, to
select ‘PRO4 mode’.
6
If the [Jog switch] is turned, the setting (red) will blink.
Select from either ‘Lock ON’ or ‘Lock OFF’.
8
If the [MODE key] is pressed once, the amplifier will return to
‘PRO4 mode’.
7
If the [Jog switch] is pressed, the setting (red) will quickly
blink on the digital display, and ‘Lock ON / OFF’ will be
confirmed.
The digital display will not blink (red) if the setting has not
been changed.
9
Press the [MODE key] once, the amplifier will return to ‘RUN
mode’ (normal sensing operation).
43
Ramco National
(800) 280-6933
www.panasonicsensors.com
