Panasonic LJ-NA02, Руководство по установке

Страница: 4 / 132

4
Installation Manual
■ Attach the Battery securely using the included screws.
in fire or accident.
the specified requirements.
or fire.
suitably qualified installer in accordance with this document
the specified method of transportation.
a fire, electric shock or failure.
in fire or
Safety Precautions
Prohibited
■ Do not disassemble the product other than by the methods described in this manual or modify the
product.
Doing so may result in fire, electric shock, short-circuit or failure.
■ Do not install the product in locations where there is high humidity, exposure to steam, vapour or cold
air, or large amounts of greasy fumes or dust, fire or exhaust gas from vehicles.
Doing so may result in fire, electric shock, short-circuit or failure.
■ Do not connect a heating appliance.
A Lithium-ion battery storage system may repetitively turn ON/OFF the power supply in short intervals
in the events of power outage and recovery. Since heating appliances cannot shut down safely in such
short periods of time, connecting them to a Lithium-ion battery storage system may result
carbon monoxide poisoning.
■ Do not place tools or other objects on the product.
Doing so may result in injury or failure.
■ Do not insert your hands or foreign objects into the vent holes or fan.
Doing so may result in injury, electric shock or failure.
Mandatory
■ All electrical wiring must comply with local electrical regulations.
Fire, electric shock, or injury may otherwise result.
■ Wear protective gloves and use insulated tools during the installation/wiring work. Heavy objects must
be handled in accordance with local regulations.
Failing to do so may result in electric shock, injury or failure.
■ Make sure that the vent holes are not blocked when installing the product.
Blocked vent holes will reduce heat dissipation and may result in fire.
■ Observe the following when installing/wiring the product:
Failure to do so may result in
> Protection device for the Lithium-ion storage battery, protection device for Network Adaptor, the
Stand-alone breaker and DC protector unit must be set to OFF until the wiring is completed.
> Prior to starting work, be sure to check that there is no voltage at all of the terminals.
> Do not allow water to enter the inside of the main body.
> Never perform any work when the scaffold and/or your hands/body are wet.
> Do not damage the insulation of any of the electrical conductors.
> Do not short-circuit the [+] and [-] cables of the Battery.
■ Establish a proper ground connection in accordance with local regulations.
Imperfect grounding may result in electric shock or failure.
■ Carry the product using
Failing to do so may result in injury.
■ The installation should be carried out by a
(Installation Manual).
Failing to do so may result in electric shock, injury
■ Install the product in an environment that meets
Failing to do so may result in injury or failure.
■ Attach the battery only after the product installation.
Failing to do so may result in electric shock or injury.
■ Before attaching the battery, be sure to attach the lower panel and verify that the battery breaker is
OFF.
Failing to do so may result in electric shock.
Failing to do so may result