Panasonic KX-TVS125, Руководство по установке

Страница: 218 / 476

7.2 UTILITY COMMANDS
218 Installation Manual
7.2.18 Circuit Condition Display (LMON)
Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter
[\] .
The following circuit conditions may be displayed.
Note
The maximum number of ports depends on the VPS model.
7.2.19 Touchtone Information Display (PUTD)
Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
To change the mode from "PUTD" to "OFF", Type PUTD again.
"Ready" : Possible to serve
"Incoming Call" : Processing arrival service
"Outgoing Call" : Processing sending service
"DSP Reset" : Processing DSP reset disposition
"PT connect" : Processing PT connect disposition
"Error" : DSP Card is not loaded
$ LMON
No.:
1: Ready
2: Ready
3: Ready
4: Ready
5: Ready
6: Ready
7: Ready
8: Ready
9: Ready
10: Ready
11: Ready
12: Ready
Status No.:
13: Error
14: Error
15: Error
16: Error
17: Error
18: Error
19: Error
20: Error
21: Error
22: Error
23: Error
24: Error Status
$ PUTD
Target Port : * * * * * * * * * * * * * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$