Panasonic KX-TVS125, Руководство по установке

Страница: 236 / 476

7.5 TROUBLESHOOTING GUIDE
236 Installation Manual
Line disconnection occurs
while transferring an
outside call.
Unable to transfer an
outside call.
• Improper setting of the
sequence.
• Improper setting of the
hooking time.
• Improper setting of the CPC
signal.
• "Tansfer to CO" not enabled
on PBX.
• Adjust the transfer sequence
to that of the connected PBX
and reset (see "Operator
Transfer Sequence" and
"Extension Transfer
Sequence" in Table B-45 in
B7.3 PBX Interface
Parameters).
• Adjust the hooking time to that
of the connected PBX and
reset (see "Flash Time" in
Table B-41 in B7.2 Port
Setting).
• Adjust the CPC signal to that
of the connected PBX and
reset (see "CPC Signal" in
Table B-41 in B7.2 Port
Setting).
Unable to call an outside
party. • Improper setting of the
outside call dial procedure. • Reset the CO line access
sequence of the connected
PBX (see "Dial Number" in
Table B-5 in B2 SYSTEM
ADMINISTRATION—
MAILBOXES and "Number of
Digits to Access Outside Line"
in Table B-32 in B6.8 Other
Parameters).
• Also check "Outgoing Call
Setup Sequence" in Table B-
32 in B6.8 Other Parameters.
• When setting a Dial Number
for Device Notification or a
telephone number for External
Message Delivery, keep in
mind the "Notice" for "Dial
Number" in Table B-5 in B2
SYSTEM
ADMINISTRATION—
MAILBOXES.
Unable to call an extension. • Improper setting of extension
numbering plan. • Adjust the extension
numbering plan properly (see
"Numbering Plan 1-16" in
Table B-31 in B6.8 Other
Parameters).
Table 7-5
PROBLEM PROBABLE CAUSE POSSIBLE SOLUTION