Panasonic KX-TVS125, Руководство по установке

Страница: 338 / 476

B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
338 Installation Manual
Message
Waiting
Lamp Ports Port No.
(1-24)
Specifies the port numbers used for the Message Waiting
Notification Lamp feature.
The VPS turns on the Message Waiting Lamp of the
extension using the port specified in this parameter. At
least 1 port must be specified.
Note
The maximum number of ports depends on the VPS
model.
Message
Waiting
Lamp for
Every
Message 1. No
2. Yes
(Yes)
If set to "Yes", the VPS will turn on the Message Waiting
Lamp of the extension each time a new message is
recorded in the mailbox. This will occur even if the
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
If set to "No", the VPS will turn on the Message Waiting
Lamp for the first message only. The VPS will not turn on
the lamp for subsequent messages until the subscriber
has accessed the VPS to retrieve the messages stored
there.
Max. Digits
for Callback
No. 1-48 digits
(20)
Specifies the maximum number of digits the caller can
enter as a callback number. This number will display on
beepers if the "Beeper Callback No. Entry Mode" is
enabled.
Callback No.
Entry
Interdigit
Time-Out 1-10 s
(5)
Sets the maximum allowable time between each digit on
Beeper Callback No. Entry. If the caller does not enter any
digits within the specified time, the VPS will not accept
entry of any additional digits.
System
Callback No. Up to 32 digits
(None)
Specifies a telephone number that will display on the
subscriber’s beeper as a callback number. The callback
number entry mode "X" must be included in the telephone
number.
Note
If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the
caller will display on the destination beeper.
However, if the caller fails to enter a callback number,
the System Callback No. will display instead.
Table B-33
Parameter Value Range
(Default)
Description/Function