Panasonic KX-TVS125, Руководство по установке

Страница: 349 / 476

B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Installation Manual 349
To program the following 10 Parameters in the next table, use the Special Commands and Dial
Codes listed below. You can set up to 12 digits for each parameter.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
Release
Sequence
for Call
Waiting
None N/A F N/A N/A F F F F F F
* When your KX-T series telephone system is in DPT Integration mode.
N/A Not available
— Not needed
Table B-44
Parameter Value Range
(Default)
Description/Function
Integration
Mode 1. None
2. Inband
3. DPT
(DPT)
Specifies the method of integrating the VPS with the
PBX.
1. None—Both PBX and VPS work independently,
without accessing information concerning the status
of the other.
2. Inband—The PBX sends touchtone codes to the
VPS to indicate the state of the call (busy, answered,
disconnect, etc.). Inband Integration improves the
VPS performance because call state recognition is
faster than with standard call progress tone
detection. The PBX code for each call state must be
set in the Inband Signaling Parameters. If PBX type
is set to a KX-T series telephone system, the Inband
Signaling Parameters will automatically default to the
proper codes. This is available with any of the
following Panasonic KX-T series telephone systems:
T1232, TA624, T96, T336, TD816, TD1232, TA1232,
TD500, TD308, and TDA/TAW series.
3. DPT—The VPS communicates with the PBX via the
DPT interface. This is available with any of the
following Panasonic KX-T series telephone systems:
TD816, TD1232, TA1232, TD500, TD308, and TDA/
TAW series.
Table B-43
PBX Type
Other
Manu-
facturers
KX-T series
T308/
T616
T1232/
TA624
T96 T336
TD816/
TD1232/
TA1232/TD308
TD500
TDA/TAW
series