Panasonic KX-TVS125, Руководство по установке

Страница: 185 / 476

5.5 SETTING MAILBOXES
Installation Manual 185
Enter the data using the following table as a guide.
Table 5-8
Parameter Value Range
(Default)
Description/Function
Dial Number Up to 32 digits
consisting of 1-9,
0, , #
P, T, M, X
(None)
Assigns a telephone or beeper number to Device 1, 2,
or 3. The subscriber can also specify the dial number
from his telephone.
P: Pause
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note
The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS
and "Type of Device" is set to "Beeper". The proper
number of "Pauses" must be inserted before the
callback entry code.
Notice
When the VPS calls to a CO line via a PRI (ISDN
Primary Rate Access Interface) card of a
Panasonic PBX, please be sure to add "#" after the
telephone number (1112223333 in the example
here):
Example: 9P1112223333#PP123PP456PPX#
Please contact your System Administrator for more
explanation.
Type of
Device 1. Telephone
2. Beeper
(Telephone)
Specifies the device to receive notification. This is
automatically set to "Beeper" when "X" is used in the
Dial Number (above). The subscriber can also specify
the type of device from his telephone.
Use Mode 1. Not Use
2. Continuously
3. Scheduled
(Continuously)
Specifies how Device 1, 2, or 3 is to be used. The
subscriber can also specify the use mode from his
telephone.
1. Not Use—Device 1, 2, or 3 is not used for a
notification call.
2. Continuously—Device 1, 2, or 3 is called whenever
a message is recorded in the mailbox.
3. Scheduled—Device 1, 2, or 3 is called on a schedule
basis when a message has been left in the mailbox.
No. of Retries 0-9 times
(0)
Specifies the number of times that a notification call to
Device 1, 2, or 3 should be attempted after a busy or no
answer condition is received.